|
|
注意:本帖含有图片和附件资料 登录 才可查看，没有帐号？
您需要 登录 才可以下载或查看，没有账号？立即注册
×
M652n，M652dn，M653dn，M653dh，M653x，M681dh，Flow M681f，M681f，Flow M681z，Flow M682z
Removal and replacement: Right lower cover (3-bin stapler/stacker)
● Introduction
● Step 1: Remove the staple cover (3-bin stapler/stacker)
● Step 2: Remove the rear cover (3-bin stapler/stacker)
● Step 3: Remove the right upper cover (3-bin stapler/stacker)
● Step 4: Remove the right corner cover (3-bin stapler/stacker)
● Step 5: Remove the staple rear cover (3-bin stapler/stacker)
● Step 6: Remove the right lower cover (3-bin stapler/stacker)
● Step 7: Unpack the replacement assembly
Introduction
This document provides the procedures to remove and replace the right lower cover on the 3-bin stapler/stacker.
Click here to view a video of this procedure.
IMPORTANT: When applicable, special installation instructions are provided for an assembly at the end of the
removal procedure. Always completely read the removal instructions and follow all special installation
instructions.
Before performing service
○ Turn the printer power off. A shutting-down message appears on the control-panel display.
WARNING! To avoid damage to the printer, turn the power off and wait until the printer shuts down before
removing the power cable.
○ Disconnect the power cable after the printer is completely shut down (the control-panel display is blank).
Use the table below to identify the correct part number for your printer. To order the part, go to
Right lower cover (3-bin stapler/stacker) part number
RC4-9439-000CN Cover, right lower
Required tools
● #2 Phillips screwdriver with a magnetic tip
After performing service
○ Connect the printer power cable.
○ Turn the printer power on.
Post service test
No post service test is available for this assembly.
|
|
发表于 2019-7-12 08:44:05
